Why you can't get backup camera video？ Manual Transmission back Camera settings If your car is a manual transmission, you need to select gear type2 or 3 in the setting(PEMP Android screen) ; The setting method is as follows: Settings> factory>pass word070305> vehicle> Gear Selection, pls select type2 or 3 Then reverse the vehicle, and the reversing screen will be displayed normally. Support the AHD and CVBS format You can connect or disconnect the plug, set the video format you want. 1.When you disconnect, it is 1080P 30FPS HD format. This must be supported by your Android screen. 2.When you connect the plug, it is 480P normal format. Most Android screens support this format. How to connect the Carmea wires? 1. Please connect the REAR camera's yellow video cable to the PEMP Android harness with the Rear Camera IN. 2. Please connect the red power cable of the camera to the PEMP Android wiring harness marked with Carmera +12V; 3. Do not connect any other wires. 4. When you are reversing, the Android interface will automatically switch the reversing screen, Carmera +12V starts to supply power to the camera, and you can see the reversing picture on the screen. Notice: 1. If you purchased the PEMP front camera, you need to connect the power of the front camera with the Camera +12V. And connect the yellow video cable of front view camera with FF Camera in. 2. PEMP Android screen, the 8.8-inch display only supports CVBS camera input; the 10.25-inch display supports AHD and CVBS reversing cameras.